![]() If you cannot find a wire that long, you can instead splice the reverse signal wire that goes to the camera near the rear camera. You'll need around 150cm of wire to do so. However, most of the sellers do not sell a wire that is long enough to go from one end to another. The wires will come out on the first try this way and save you time and a lot of swearing.Ģ) When wiring the driver side reverse light, you will need the repair wire as mentioned in my original post. Okay so I've been doing this install a number of times now for other people and here are some additional notes/tips:ġ) I would highly recommend buying repinning "keys"/tool from Amazon instead of the sewing needles. 000979025EĪnd now you are all done! Stand back and enjoy your work! Use this wire for best results: VW part no. This will turn both of your reverse lamps back on. Step 6 (Optional) ) Run a wire from the right side inner reverse lamp to the left side inner reverse lamp to bridge them.e) Leuchte 20 and 21 are lasttyp #34 (braking LEDs).d) Leuchte 27 and 28 lasttyp are #35 (blinking LEDs) and,.c) Leuchte28 is your new left turn signal.b) Leuchte20 and 21 are no longer your turn signals.a) Leuchte27 is your right turn signal.Step 4) On the driver outer tail light, remove the wire going into pin 4 and tape the end of it.This will disable your driver side reverse light and turn it into the amber signal for the driver side instead. Then press the locking tab back down on the connector. Step 3) Take that wire and put it into hole #3. ![]() You can do this by unclipping the lock at the top of the conector, and then putting 2 sewing needles into the holes on the top and bottom of the connector to unlock the wire.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |